|
| ¡¡¡¡Company |
VM type dense phase tower flue gas desulfurization technology:
A kind of advanced desulphurization technology introduced from Germany, its main characteristic:
¡ó High utilization ratio of desulfurizer and high efficiency of desulphurization;
¡ó Low water rate ;
¡ó The rotation device in the reaction tower makes the desulphurizer move according to the fixed direction, which formed two phase flow of the desulphurizer and exhaust gas and strengthened the course that the desulphurization reacts greatly ;
¡ó The desulphurizer is in dry state in the whole desulphurization course ;
¡ó Good adaptability ;
¡ó The dry tower is made of ordinary steel, and does not need the antiseptic measures of the special type , such as alloy , coating and rubber lining ,etc. ;
¡ó The operate temperature is higher than the dew point ,no phenomenon of corroded or condensation
¡ó No waste water be produced
¡ó The exhaust gas does not need to heat again and can be discharged
Lime stone - gypsum flue gas desulfurization processing:
A kind of ripe wet desulphurization technology introduced from Japan, its technological characteristic lies in:
¡ó The liquid post tower is square and can be regulated according to the place.
¡ó The spray system adopts the female type tube and the single layer of low location, simple to run and convenient to maintenance.
¡ó The systematic procedure can arrange flowing , adverse current and mixing three ways of flowing to set up according to the exhaust gas condition , the alternative is relatively strong .
¡ó The dust removal rate is high.
¡ó The craft system is reliable.
Mg (OH ) 2flue gas desulfurization processing£º
A kind of advanced wet desulphurization craft introduced from Japan £¬its Main craft characteristic:
¡ó High efficiency
¡ó No dirt formed
¡ó Convenient to operate and maintenance
¡ó Compactness
¡ó Discharge up to standard
Blowback flue gas desulfurization processing:
It is a kind of wet desulphurization technology introduced from Japan .
Its technological characteristic:
¡ó Low expenses of building , less 25% than other processing.
¡ó Low costs to run , the current drain can be reduced to 40%
¡ó Simple to operate and reliable to run
¡ó Suitable for the technological improvement project of the existing spray tower with weak desulphurization at the same time
¡ó Adopt different absorption medium to adapt the exhaust gas SO2 density
|
|
|
